You have no items in your shopping cart.
Finding the perfect place to mount your AutoMeter gauge has just been made easier. Using AutoMeter's Omni-Pod gauge cup, you can mount your AirDrive, digital, or digital stepper motor gauge anywhere you see fit. The Omni-Pod can be mounted on top, or under the dash. The bendable base allows the mounting cup to be contoured to nearly any surface. The possibilities are endless.
- ADDITIONAL NOTES
- Ultra lightweight composite housing sheds over 50% of the weight compared to a standard AutoMeter universal gauge pod.
- Bendable metal base enables you to mount the gauge pod nearly anywhere.
- No cutting or drilling for installation.
- Compatible with AutoMeter AirDrive, Digital, and Digital Stepper motor gauges only. NOT COMPATIBLE with Air-Core or Mechanical Gauges.
- SHIPPED WITH
- Bracket Included
Will this Omni holder fit a 5307 ES boost gauge without modification?Thank you so much for contacting us. Unfortunately the Omni Pod will not work with a mechanical gauge. Due to its smaller size, it will only work with our Digitial Stepper Motor and Digital gauges. You could use this ES boost gauge with it: https://www.autometer.com/2-1-16-boost-vac-30-in-hg-30-psi-fse-es.html Or you could use this pod with a mechanical gauge: https://www.autometer.com/2-mounting-cup-black.html Hope this helps!Date published: 2018-05-03
Are these cups tampered? for example, if I only need an inch or 1.25" cup depth, can I trimmed these down and still hold the 2 1/16" gauge? ThanksHi Brett, thank you for reaching out. There is a very slight taper, but we would not recommend trimming or cutting down the 2205 cup in any situation. It's already a very shallow cup at 1.850 inches compared with our metal cups, which are around 2.6" in depth.Date published: 2018-03-05
Would the 2697 in dash tach 2-1/16", fit in this pod?Hi Rodrigo, thank you for connecting with us. Yes, the 2697 Tachometer will fit into this cup, but you will have to trim the mounting studs on the tachometer, which would be required for any other cup mount that we offer.Date published: 2018-02-12
what are the dimensions of the omni pod low profile gauge pod? ie, height, depth or width, not diameter I know if fits a 2 1/16 gauge.Hi Buzz, thank you for contacting us. The cup itself is 1.850" deep and the cup and mount are around 2.625" high (that will vary slightly depending on the angle you have the gauge at). Hope this helps!Date published: 2018-02-07
California Prop 65 Warning