You have no items in your shopping cart.
SENSOR, TEMPERATURE, 1/8" NPTF MALE, REPLACEMENT, AUTO GAGE
- ADDITIONAL NOTES
- Sensor Body Material - Brass
- Thread size - 1/8 in. NPTF
- Includes 3/8 in. NPT and 1/2 in. NPT adapter bushings.
- SHIPPED WITH
i have a 1990 f250 will this fit my transmission plug located just above the pan.Thank you for your inquiry. Unfortunately we do not have port data for specific transmissions. This sender is 1/8" NPT.Date published: 2020-02-19
I have a 2in Procomp Ultralite 140-300 oil temp and a couple of the water temp 100-250 range guages and air/fuel ratio guage. What sensors would I need to make these work properly? Does autometer make holders in 2 or 3 clusters ?Thank you for your inquiry. Both gauges use a 2258 sender: https://www.autometer.com/short-sweep-electric-temp-gauge-sender-250-300-and-340-deg.html See this link for mounting solutions: https://www.autometer.com/mounting-solutions/universal.html#1&profile=productsDate published: 2020-02-11
Can I use this to replace a trans temperature sensor from 140 to 260Thank you for your inquiry. This sender will not work with trans temp gauges. It is designed only for use with Auto Gage 1-1/2" water temp gauges.Date published: 2020-02-06
Is this sender unit compatible with other gauges? It will be used in a marine application?Thank you for your inquiry. The 2385 is designed only for our 1-1/2" electric water temp gauges. It will not work with other gauges.Date published: 2020-02-06
Will this sensor work on the COBALT series temp gauge? Thank you for your question. You will need P/N: 2258 for any of our short sweep electric gauges.Date published: 2020-02-04
Does this fit a ABC oil drain plug holeThank you for your inquiry. It is not advised to install this temp sensor into an oil drain hole. It should be mounted where it is undisturbed, either drilling and tapping the pan to accept the sender or adapters, or by use of the 2260 weld-in bung: https://www.autometer.com/1-8-npt-weld-in-adapter.htmlDate published: 2020-01-29
Will this work as a replacement for my electric triple guage set that was a 180 degree sweep that goes from 100* to 280* Thank you for your inquiry. The 2385 sender is correct for Auto Gage electric water temperature gauges, including the one in your 3 gauge panel.Date published: 2019-12-17
I have your Auto Meter Pro Comp Ultra Lite Trans Temp gauge 100-250* and i need the sending unit is the 2385 the correct one ?Thank you for your question. No, you will want to use either 2258 or the 2259. The only difference being the 2259 is for shallow depth applications and the 2258 is the standard included sensor, other than that they have the exact same specs.Date published: 2019-11-07
California Prop 65 Warning