You have no items in your shopping cart.
- Description
-
MAGNETIC TRIGGER, DRIVESHAFT RPM, REPLACEMENT, FOR ULTIMATE TACHOMETER
- ADDITIONAL NOTES
-
Feature Points
- For use with Ultimate and Ultimate II Tachometers only. Not compatible with Ultimate III or DL Tachometers (see ST269532)
- SHIPPED WITH
-
- Reviews
-
- Questions
-
Hi I am using this hall sensor #5212 for wheel speed wired into a motec ecu. Question what is the required + voltage 5v 8v or 12v Thanks
Thank you for your inquiry. The 5212 is a 12 volt sensor.Date published: 2019-07-02Can I check my existing magnetic drive shaft trigger with a ohm meter. Its a threee wire and I get no resistence across any of the wires. Is there an certain resistence it should be? Thanks Paul Stewart
Hi Paul, thank you for connecting with us. This will likely require some additional dialogue with our Technical Support Team. I would recommend reaching out to us at 866.248.6356 or emailing us and we we can get some information on your issue and how best to troubleshoot it. Here is a link to email us: http://www.autometer.com/resources/index/ask_a_questionDate published: 2018-02-21
California Prop 65 Warning
