You have no items in your shopping cart.
Since 1957, AutoMeter has set the standard in performance, accuracy and durability with their legendary Tachometers. The absolute pinnacle of engineering and technology, it’s no wonder AutoMeter can lay claim to more motorsports victories than every other gauge manufacturer combined. The patented air core meter movement, wound in house to exacting standards, can move the needle from 0 - 10,000 rpm in 333 milliseconds. An inaugural inductee to the Hot Rod Speed Parts Hall of Fame, no other tachometer on the market has had anything approaching its impact on professional racing. Built for a lifetime of service under the harshest conditions, this is the no compromise tach for no compromise builds. When you’re ready for the best, there isn’t another choice.
- ADDITIONAL NOTES
- Traditional incandescent lighting illuminates around the perimeter of the dial
- Compatible with most 4, 6, and 8 cylinder engines (2 - 4 pulse per revolution ignition signals) with points, electronic, and most 12V high-performance racing ignitions.
- 12 and 16 volt compatible, well-suited with nearly every street car or race car electrical system
- Gauge kit includes bulb and socket assembly, red and green bulb covers, mounting hardware, and detailed instructions for installation
- AutoMeter’s race proven air-core electric tachometers provide quick and accurate readings with a needle so responsive it can go from 0 - full scale in 333 milliseconds
- SHIPPED WITH
Bulb & Socket
- Red 3214 & Green 3215
- Bracket Included
I have this tach and when engine turns over needle jumps as it is receiving signal but goes to zero and doesn't move when engine starts and is running. Please Help. Thanks ChuckThank you for your question. This issue is going to need more in depth troubleshooting help to resolve. I recommend you contact our support team as they can better assist you with this. You can reach them at 866.248.6357 or https://www.autometer.com/contactsDate published: 2019-01-03
I have the Pathom tach and it is jump or a twitch at idle. I have the MSD 6AL and a MSD Tach Adapter. Its 1970 Chevelle 400 small block HEI distributorHi Vonnie, thank you so much for contacting us. A couple things. One, with an AutoMeter tach, you won't need to use an MSD tach adapter. The signal wire from the tach should go directly to the tach output on the MSD box. If it's got a little twitch to it at idle, it's commonly due to electrical/RF noise. In many cases you can very easily mitigate this by installing a 10k ohm resistor in line with the signal wire. We detail that procedure here: https://www.youtube.com/watch?v=-6j3glUtecY Of course, all the basics like making sure you've got a good engine or chassis ground and a steady power supply >12.5 VDC while running are always important. Hope this helps!Date published: 2018-04-25
does this have the dedicated shift light connecter to install a shift light without the rpm controller?Thank you so much for contacting us. This tachometer unfortunately does not have the ability to control a shift light. As a general rule of thumb, there will be a way to adjust the shift light settings on the front of the tach if it has that feature (either pushbuttons or a knob). Hope this helps!Date published: 2017-11-20
California Prop 65 Warning